Complaint
Product overview
F-TL desulfurization pump is a new generation high-efficient desulfurization pump based on the successful design experience of ZM series slurry pump. It absorbs domestic and foreign advanced technology of the same type products and is designed aimed at flue gas desulfurization pump properties in our country. Its maximum flow range reaches 12000m3/h. Its lift is normally below 100m, covering all desulfurization system pump working conditions. It can be used as absorbing tower large-scale slurry circulating pump or limestone slurry transporting pump, gypsum slurry discharge pump, recovery pump and pit pump etc.
Structure
FT-L type applies horizontal, single pump shell, single-stage single-suction, bracket(suspension) type structure. It applies flexible coupling.
| 1 | Before the pump cover | 2 | Impeller nut | 3 | Chuck | 4 | Before the liner | 5 | Pump body | 6 | Impeller |
| 7 | After the pump cover | 8 | Mechanical seal | 9 | Before the dust disk | 10 | Front axle bearing cover | 11 | Shaft | 12 | Bearing box |
| 13 | Rear axle beaing cover | 14 | Ater the dust-prod plate | 15 | Bearing box bracket |
| 1 | Before the pump cover | 2 | Impeller nut | 3 | Chuck | 4 | Before the liner | 5 | Pump body | 6 | Impeller |
| 7 | After the pump cover | 8 | Mechanical seal | 9 | Before the dust disk | 10 | Front axle bearing cover | 11 | Shaft | 12 | Bearing box |
| 13 | Rear axle beaing cover | 14 | Ater the dust-prod plate | 15 | Bearing box bracket |
| 1 | Before the pump cover | 2 | Before the liner | 3 | Pump body | 4 | Impeller | 5 | Impeller nul component | 6 | After the pump cover |
| 7 | Machine sealing collar | 8 | Mechanical seal | 9 | Shaft | 10 | Before the dust disk | 11 | Front axle bearing cover | 12 | Bearing box |
| 13 | Bearing box brackel | 14 | Rear axle bearing cover | 15 | Ater the dust-prool plate |
Performance parameters of the table
